| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN THE MACHINE ON AND PUSH THE BRUSH BUTTON TO LOWER THE BRUSH DECK. TURN MACHINE OFF.
|
| 2 |
|
SLIDE THE BRUSH OUT FROM BRUSH DECK.
|
| 3 |
|
REMOVE THE 5 SCREWS HOLDING THE BRUSH DECK COVER.
| Wrench-Allen metric 5.0mm |
|
|
| 4 |
|
REMOVE THE SCREW FROM THE BUMPER WHEEL.
| Wrench-Allen metric 5.0mm |
|
|
| 5 |
|
SLIDE THE BRUSH COVER FROM BRUSH DECK.
|
| 9 |
|
NOTE: THE BRUSH DECK HAS BEEN REMOVED FROM MACHINE FOR ILLUSTRATION PURPOSES ONLY. YOU DO NOT HAVE TO REMOVE THE BRUSH DECK. REMOVE THE 4 BOLTS HOLDING THE BRUSH MOTOR TO THE BRACKET.
| Wrench-Allen metric 4.0mm |
|
|
| 10 |
|
REMOVE THE BOLT HOLDING THE LEFT BELT GEAR TO THE BRUSH DECK.
| Wrench-Allen metric 4.0mm |
|
|
| 12 |
|
SLIDE THE BELT FROM THE BRUSH MOTOR.
|
| 13 |
|
REMOVE THE 4 BOLTS HOLDING THE WHITE BEVEL GEAR TO THE BRUSH DECK.
| Wrench-Allen metric 5.0mm |
|
|
| 14 |
|
THE 4 BOLTS AND 8 WASHERS ARE NOW REMOVED FROM THE BEVEL GEAR BRACKET.
|
| 15 |
|
LIFT UP ON THE BEVEL GEAR ASSEMBLY TO REMOVE IT FROM THE BRUSH DECK.
|
| 16 |
|
REMOVE THE BOLT HOLDING THE RIGHT BELT GEAR TO THE BRUSH DECK.
| Wrench-Allen metric 4.0mm |
|
|
| 17 |
|
REMOVE THE BOLT HOLDING THE RIGHT BELT GEAR TO THE BRUSH DECK.
|
| 18 |
|
VISUALLY INSPECT BOTH IDLER BEARINGS FOR DAMAGE SUCH AS, BEING WARPED OR SEPARATED. TURN THE BEARING TO CHECK FOR LOCKED UP CONDITION. IF THE BEARINGS ARE OKAY, REVERSE STEPS 2 THRU 17 TO REASSEMBLE THE MACHINE.
|
| 19 |
|
NOTE: WHEN REINSTALLING THE GEARS, THE POINTER ON THE GEAR NEEDS TO BE LINED UP WITH THE SLOT ON THE BASE PLATE.
|